glass cutting

What drill bit kit is best used for drilling holes for 3/4” PVC pipe to be installed? I’m only coming across ceramic drill bits

I am sure there are countless threads with this same question. But to make a long story short, I recently purchased a new Aqueon 6 ft 125 gallon tank. I have the stand built and am ready to start the plumbing and I am trying to figure out of the tank is made with tempered glass. There arent any...

I just finished drilling my tank for an overflow, followed the template, and the interior box hits the glass lip on the inside of the tank. Most tanks I've looked at don't have the lip, so is it safe to cut that piece for some clearance? What is the best way to cut glass that thick that is...

Hello folks I am pretty new to the hobby i got my 90 gallon tank setup by professional company. However, i didn't notice that the glass is only from one corner slightly not fit on the table .. the tank is cycled and running for 2 months now .. looks pretty stable and strong. Nonetheless that...

Hello all, My friend is trying to join this wonderful hobby of ours and just purchased his first tank. Only problem is, it is a rimless tank. I have no experience with a rimless tank. So I have a few questions. 1) What did you guys do for lids? 2) how far down should we drill the...

I'm fairly certain that this is a bad idea, but there is a reason behind it. My 90 gallon has half of its top under plate glass that is built into the tank are part of the bracing, I guess. That glass is nuking my PAR levels for everything under it. I'd like to cut holes in that bracing. I THINK...